MK Diamond Scarifier - Manual (Page 25)

25
MK-Scarifier aSSeMBLY
cUTTiNg DrUM iNSTaLLaTiON
The Cutting Drum may be disassembled from either end. NOTe:
(A)
Install the Cutting Drum; align
the Cutting Drum with the
Shaft-side Bearing and install
the Cutting Drum, Shaft.
(D)
Using a 15/16-inch socket
tighten the Shaft, Inner
Retaining Nut, counterclock-
wise.
(G)
Using a 15/16-inch socket
tighten the Shaft, Outer
Retaining Nut.
(B)
Verify the Cutting Drum and
Shaft are fully installed and
seated.
(E)
Obtain the Shaft, Outer
Retaining Nut.
(H)
Install the Shaft, Retaining Nut
Cover onto the Belt Guard.
(C)
Install the Shaft, Inner Re-
taining Nut.
(F)
Install the Shaft, Outer
Retaining Nut.
(I)
Pivot the Shaft Guard Cover
into position and install the
Rear Retaining Bolt.
fiLLiNg OiL reSerVOir
SAE 10W-30 is recommended for general use in temperatures of – 4ºF (20ºC) and above.
Engine Oil Capacity is 1.16 US qt (1.1l). Refer to Engine Manual for details.
NOTe: