MK Diamond Scarifier - Manual (Page 32)

32
MK-Scarifier cLeaNUP
(D)
Clean the Depth
Control Screw.
(E)
Clean the remainder of the
exterior surface of the scari-
fier (except the engine).
(F)
Clean engine throttle linkage
with a dry cloth.
(G)
Remove the Cutting Drum
(See Setup Section).
(H)
Clean the Shaft Penetration
Hole of the Cutting Drum.
(I)
Clean the Cutting Drum,
Shaft.
New Maintenance
Perform the following after initial purchase and operation of the saw.
(A)
Change engine oil after 1st
month or 1st 20 operating
hours (See Engine Manual).
(B)
Check and adjust tension on
all V-belts following 1st 48
hours of operation (See V-
belt Inspection).