MK Diamond Scarifier - Manual (Page 24)

24
MK-Scarifier aSSeMBLY
(A)
Pull the Cutting Disc Shafts
out the open side of the Cut-
ting Drum as shown.
(D)
Place the Cutting Drum on
the closed end, with the open
end facing upward.
(G)
Place the Retaining Ring
onto the end of the Cutting
Drum, aligning the Retaining
Screw Holes.
(B)
Assemble the Cutting Drum
using Cutting Discs and Disc
Spacers (See Cutting Drum
Configuration).
(E)
Obtain the Retaining Ring
and Flat Washer Spacers.
(H)
Install the 3 Retaining Screws
into the Cutting Drum (do not
cross-thread the screws).
(C)
Continue with Step B until
the Cutting Drum assembly is
complete.
(F)
Install the 3 Flat Washer
Spacers (if used) over the
3 Retaining Ring, Retaining
Screw holes.
(I)
Tighten the 3 Retaining
Screws using a 7/16-inch
wrench.
cUTTiNg DrUM aSSeMBLY
The Cutting Drum may be disassembled from either end. NOTe: