MTS Criterion Series 60 - Manual (Page 48)

Positioning the Actuator
You can position the table/upper crosshead using the controls outlined in red below. The lower crosshead
can only be positioned using the load unit control (LUC) module.
Setting up Meters
Right-click to show the Meter Type menu.
Installing an Extensometer
TWX requires that the extensometer have its setup, calibration, and verification parameters stored in a
TEDS file. Use the Controller menu to display the TEDS Devices window and then select the correct
TEDS file for the extensometer you are using.
48 | MTS Criterion ™ Series 60
System Introduction