Quadrox QGuard Installation Manual - Manual (Page 17)

GuardNVR Installation Manual 17
Version 4.4 Series
2.3.4.1 Through GuardNVR Web Application
Time synchronization allows you to synchronize time on all devices connected to your unit
(e.g. cameras) and synchronize your server with a specific time server. This can be done by
going to the Settings menu in the Video Manager Web Application and selecting the Time
Synchronisation link in the top bar
Time Synchronization Screen
There are three options:
Use video server as a (proxy) time server – The unit will synchronize with an
external time server if configured in the bottom part of the screen. If empty, the unit
will act as a time server for itself and the connected devices (e.g. cameras).
Synchronize all devices with an external time server – The unit and all the
connected devices (e.g. cameras) will be synchronized with an external time server.
Configure the IP address or DNS name of the external time server in the bottom part of
the screen.
Manually configure time synchronization on each device separately (not
recommended) – No synchronization at all is performed, neither for the unit nor for
the connected devices (e.g. cameras)
If your unit is part of a domain, this menu will not be available. The unit and
connected devices (e.g. cameras) will be synchronized automatically with the Active
Directory of the domain.
Click Apply to save the settings.
2.3.4.2 Through Operating System (XP or Vista)
2.3.4.2.1 Changing time zone
To change the time zone, follow the steps below:
In Control Panel, in the left upper corner click the link ‘Switch to Classic view’.
When in classic view, select Date & Time from the right-hand list.
On the Date and Time properties dialog, select the tab ‘Time Zone’ (XP) or click
‘Change Time Zone’ (Vista)
When in the ‘Time Zone’ menu, select the correct time zone.
Click OK to save the ‘Date and Time’ changes.