Sensaphone 1800 - Manual (Page 34)

Sensaphone 1800 Manual
32
2. Press the CONFIGURE key.
The 1800 will announce each Zone number and its detected Zone
type.
The Zones are now considered normal. If a normally closed Zone
becomes open, an alarm will occur. If a normally open Zone
becomes closed, an alarm will occur.
MANUAL ZONE CONFIGURATION
If you would like to program the Zone type (NO, NC, temperature,
4–20mA) without going through the automatic process that scans
all Zones, this command will allow you to configure a single Zone.
This command is useful if you have alarms on other channels and
cannot use the automatic configuration process, or if you wish to
configure the Zone type without actually connecting the sensor.
NOTE: You MUST use manual configuration for
any zone connecting to a 10K temperature sensor.
To configure the Zone Type:
1. Press the SENSOR ON/OFF key.
2. Press the TABLE RANGE key.
The 1800 will say “Enter Number.”