Installation, Optional accent light installation – Regency Bellavista B36XT Medium Gas Fireplace User Manual
Page 53
Regency Bellavista™ B36XT Gas Fireplace
53
INSTALLATION
Important: 120 Volt AC power is required to operate the light.
The receptacle box will be installed on the left hand side of the unit
and will need to be wired by a qualifi ed electrician prior to the light
installation. The neutral (wider) slot of the polarized receptacle
should be at the top. A wall mounted switch should also be installed
to turn the accent light on and off.
Note: Receptacle Box is switch operated.
Refer to wiring diagram in the manual.
1) Shut off electrical supply.
2) Remove the louvers / full screen doors - if installed.
3) Remove the glass door.
4) Remove the logs - if installed.
5) Remove the rear log tray by removing 2 screws (locations shown
below) then lifting out.
Cover plate
Light assembly
wiring
Protective Sheath
Connectors
Rear Log Tray
Cable Tie
6) Remove the 2 screws securing the cover plate to the fi rebox base.
Discard cover plate - keep the 2 screws.
7) From inside the fi rebox - feed the wires
from the bottom of the light assembly
- through the opening exposed after the
removal of the cover plate.
8) When light assembly has been fully seated -
secure in place with 2 screws that were removed from the
cover plate
9) From underneath the fi rebox - slide back the protective sheath
on the plug wiring to reveal connectors.
10) Plug the red light assembly wiring into the blue plug wiring - as
shown below.
11) Slide protective sheath back over connectors until it meets the
underside of the fi rebox base - to protect wires.
Secure end of sheath with a cable tie.
B36XT/B36XTE Accent Light Kit # 576-959
1
Light Assembly
-includes cable tie/ gasket.
1
910-997
Halogen Bulb
1
940-363
Amber glass
1
910-199
Adhesive wire clip
1
918-821
Instruction Sheet
NOTE: The ground wire will need to be pulled back out of the protective
casing to be able to reach the ground lug. Gently pull the end
of the green wire backwards exposing enough wire to reach
ground lug.
OPTIONAL ACCENT LIGHT INSTALLATION