Rockwell Automation 1395 Discrete Adapter, Rev 3.XX-8.XX - Manual (Page 14)

4 Chapter
4-1
Installation
Introduction
This chapter is a detailed procedure for the proper installation and
electrical interconnection of the Bulletin 1395 Discrete Adapter Board.
Procedures you will perform in this chapter include:
S Verification of proper unpacking and inspection
S Verification of proper mounting
S Verification of proper wiring
Receiving
It is your responsibility to thoroughly inspect the equipment before
accepting shipment from the freight company. You must take the
responsibility for noting any damage. Do Not accept shipment before
checking all items received against the purchase order, and noting any
missing or damaged items on the Freight bill.
If any concealed damage is found later during unpacking, it is your
responsibility to notify the freight agent. Leave the shipping container
intact and request that the freight agent make a visual inspection of the
shipment.
ESD Precautions
ATTENTION: The CMOS devices used on the control circuit
boards can be destroyed or damaged by static charges. If
personnel will be working near static sensitive devices, they
must be appropriately grounded. If you are not familiar with
static control procedures, before servicing, reference
Allen-Bradley Publication 8000-4.5.2, Guarding against
Electrostaic Damage or any other applicable ESD protection
handbook.
Unpacking & Inspection
Remove all packing material from around the board, including the
anti-static bag. The Discrete Adapter Board is a static sensitive device, and
special precautions should be taken while handling the board. The circuit
card can be damaged by Electro-Static Discharge. It is possible to make
contact with an ESD sensitive component during installation. Therefore
personnel must be properly grounded. Grounding should be accomplished
with a wrist strap which is connected to an approved ground.