Rockwell Automation 1395 Discrete Adapter, Rev 3.XX-8.XX - Manual (Page 15)

Chapter 4
Installation
4-2
If the board will not be installed when it is unpacked, it should be stored in
a clean dry place in the anti-static bag. The storage temperature must be
between 0
°
C (32
°
F) and +60
°
C (140
°
F) with a maximum humidity of 95%
non-condensing, to guard against damage to temperature sensitive
components.
Mounting
On 1 – 100 HP 230V and 2 – 200 HP 460V the Discrete Adapter Board is
mounted on the front of the swing out panel (refer to system drawings. Two
possible adapter board mounting positions are provided. When looking at
the mounting positions from the front, the right position corresponds to
Port B and the left to Port A. The port used is dependent on the specific
application of the Drive.
After determining which port the Discrete Adapter Board will be connected
to, mount the board using the five panel screws and one phillips head screw
(
Figure 4.1 illustrates the Discrete Board in Port A). On 125 – 300 HP
230V and 250 – 600 HP drives, the Discrete board is mounted on a swing
out panel below the Unit Power Supply near the bottom of the cabinet
(refer to system drawings for component locations on units higher than
600 HP).