Rockwell Automation 1395 Discrete Adapter, Rev 3.XX-8.XX - Manual (Page 5)

1 Chapter
1-1
Introduction
Manual Objectives
This manual contains the information necessary to help you perform the
following functions on the Bulletin 1395 Discrete Adapter Board option:
S Install Hardware
S Verify correct Adapter Board input and output wiring
S Configure the Adapter control to the Drive and its application
This manual is intended for use by personnel familiar with the functions of
solid state Drive equipment. Qualified personnel must thoroughly
familiarize themselves with both the 1395 control and hardware before
attempting to configure the Adapter Board to the Drive.
Documentation
Information pertaining to the 1395 Drive is provided in several different
documents which includes a main Installation Manual in addition to
peripheral manuals on optional adapter boards.
This manual describes the functionality for Discrete Adapter firmware
version 3.xx (The “xx” designator may vary but does not effect information
in this manual).
Description of Equipment
Adapter boards provide an interface between external devices and the 1395
Main Control Board. The Discrete Adapter Board allows the 1395 Drive to
be controlled using discrete devices such as pushbuttons, relays,
potentiometers, and by analog signals. The Discrete Adapter has the
following features:
S Four Discrete Inputs – Can be either 120V AC or 24V DC and are
programmable to any of the 16 Logic command Bits.
S Two Discrete Contact Outputs – Programmable to any of the 16 Logic
status Bits.
S Four Analog Inputs – Configurable to represent any of the 1395 signal
inputs or the input of another Adapter Board. Programmable Gain and
Offset provides maximum interface flexibility.
S Four Analog Outputs – Configurable to represent any of the 1395
signal outputs or the output of another Adapter Board. Programmable
Gain and Offset provides interface flexibility.
S DC Power Supply – A ±
10V DC Power Supply is provided to power
potentiometers connected to the analog inputs.