Rockwell Automation 1503FC IntelliVAC Contactor Control Module - Series E - Manual (Page 36)

Chapter
4
1503-UM053B-EN-P – June 2013
Setup and Commissioning
IntelliVAC Configuration The IntelliVAC module is configured for a specific application by setting
DIP switches. They are accessed by loosening the two screws on the front
of the unit, and removing the cover by sliding it forward. The switches
are found on the front edge of the IntelliVAC circuit board (see Figure
4.1). There are 16 switches, with number 1 being at the top closest to the
circuit board part number label. (Refer to Table 4.B).
S H O C K H A Z A R D S H O C K H A Z A R D
Hazardous voltage is present inside the module
which may cause personal injury or death.
Remove all sources of power from the module
and discharge any connected capacitors before
removing the cover.
I M P O R T A N T I M P O R T A N T
Remove power from the module before
removing the cover and before changing the
DIP switch settings. The new DIP switch
settings are recognized only on power-up.
Ground Stud
Supply Power Input
Status Relay Outputs
LEDs
DIP Switches
Interface Connections
Figure 4.1 – DIP Switch and Connector Locations