Rockwell Automation 1441-DYN25-MRUC Run Up Coast Down Extension Module for the Dynamix 2500 - Manual (Page 30)

30 Rockwell Automation Publication 1441-UM006A-EN-P - May 2011
Chapter 2 Run Up/Coast Down Extension Module
Display the Table
When you are done setting up the table parameters, you can process the data and
display the table by pressing F4 (Display) on the RUCD - Table Setup screen.
Up to two orders of the magnitude and phase data set is displayed in the table:
• To scroll through the table, press the Up and Down arrows.
• You can also display the data in a Bode plot. To display the data in a Bode
plot or Nyquist plot, press 0 (Shift) and F4 (Bode).
See Display the Bode Plot on page 24 .
• To display the data in a Nyquist plot, press 0 (Shift) and F1 (Nyquist).
See Display the Nyquist Plot on page 27 .