Rockwell Automation 1441-DYN25-MRUC Run Up Coast Down Extension Module for the Dynamix 2500 - Manual (Page 40)

40 Rockwell Automation Publication 1441-UM006A-EN-P - May 2011
Chapter 2 Run Up/Coast Down Extension Module
Save Run Up/Coast Down
Measurements The Run Up/Coast Down setup parameters and measurements can be saved to a
file which you can recall at a later time. The collected data is saved in the form of
a time waveform (.wav file).
You can save the RUCD setup and measurement anytime the Save function is
displayed on the screen.
Follow these steps to save a RUCD measurement.
1. Do one of the following:
• Press F3 (Save) if you are saving the data from the Setup screen.
• Press F4 (Save) if you are saving the recorded data from a plot screen.
The RUCD - Save Data screen appears.
2. Do one of the following:
• To save the data to an existing file, highlight the file, and press F4 (Save).
Press F2 (Yes) to overwrite the existing file. You can return to the Save
screen without overwriting the file by pressing F3 (No).
• To save the data to a new file, highlight save reading as and press F4
(Save). Enter a file name using the keypad or accept the default file
name (current date timestamp).
3. When the entry is complete, press F4 (OK).
4. When you are finished, press F1 (Cancel).
IMPORTANT The setup parameters are saved along with the measurement
when you press F4 (Save) on the RUCD - Save Data screen.