Saving parameter values – Rockwell Automation 1201 GRAPHIC PROGRAM TERM 3.XX User Manual
Page 18
Chapter 2
Parameter Option
2–5
Use the
or
keys to change the value (Figure 2.9) or
enter the value directly with the numeric keys.
Figure 2.9
Parameter Value Change
Value :
<
175.2
>
RPM
To save your new value in RAM, press the
key.
IMPORTANT: This is only necessary when a value is entered directly with
the numeric keys. If the INC and DEC keys were used to enter the value,
the value is automatically stored in RAM (Drive).
To store your new value to BRAM, press the
ESC
key. A message
will appear (Figure 2.10), asking if you wish to save the parameter.
Figure 2.10
Parameter Change Verification
Do You Wish to
Save Parameters / Links (Y/N)
F1
F4
Yes
No
To save the new value, press
F1
. To leave the parameter at the
previous value, press
F4
.
Saving Parameter
Values