Rockwell Automation 1201 GRAPHIC PROGRAM TERM 3.XX - Manual (Page 49)

Chapter 7
Process Display
7–4
From any Process Display window press the
F1
soft key to
call up the Configuration display (Figure 7.5).
Figure 7.5
Configuration Display
0.00 FREQ CMD
0.00 VEL FB
0.00 COMP PWR
0.00 MTR V FB
0.00 MTR I FB
0.00 TORQ FB
Data
Parameter: 266
Scale: +1.0
Text: FREQ CMD
Program Disable Recall Init_ALL
< >
To disable a process display variable use the or key
to place the cursors on the variable you wish to Disable. Press the
F2
soft designator. The data display window will change to
display “None” in the parameter line (Figure 7.6).
Figure 7.6
Disable Parameter Configuration Display
0
0.00 VEL FB
0.00 COMP PWR
0.00 MTR V FB
0.20 MTR I FB
0.00 TORQ FB
Program Disable Recall Init_ALL
Data
Parameter: None
Scale: +1.00
Text:
< >
If you wish to re-enable the parameter that was just removed press the
F2
soft designator key again. The
F2
soft designator has now changed to an Enable variable.
Accessing the Configuration Mode
Disabling a Process Display
Variable