Rockwell Automation 1441-DYN25-MBAL Balancing Extension Module for the Dynamix 2500 User Manual
Page 59
Rockwell Automation Publication 1441-UM004A-EN-P - May 2011
59
Balancing Extension Module Chapter 2
6.
Verify the transducer and press OK.
The Trim Run 1 – Plane 2 screen appears, showing the amount of residual
unbalance on Plane 2 with the trim weights attached.
7.
Verify whether the amount of residual unbalance is within specifications.
8.
From the Trim Run 1 – Plane 2 screen, press Enter.
You are again prompted whether you wish to trim the residual unbalance.
9.
If the amount of residual unbalance is within specifications, you can end
the balance measurement, if not, you should proceed with another trim
run.
When you press No to the Trim Residual prompt, the Vibration Summary
Table automatically appears showing a summary of your measurement’s
balancing data.