Rockwell Automation 1336-GM1 Remote I/O Communications Module - Manual (Page 13)

Overview 1–3
Compatibility SCANport Products
Remote I/O modules are compatible with many SCANport products,
including the following:
If you intend to use datalinks to communicate with and control your
SCANport product, verify that your SCANport product supports
datalinks before enabling them in the module.
Controllers
This Remote I/O communications module is compatible with many
programmable controllers, including the following:
• Logix5550
• PLC-2/30 ® with SD2 (module version 1.02 or later)
• PLC-3 ®
• PLC Classic Family, including the PLC-5/10 (only with 1771-SN
in Discrete Mode), PLC-5/15
™ , PLC-5/25 ™ family
• PLC Enhanced family, including the PLC-5/20 ™ , PLC-5/30,
PLC-5/40 ™ , PLC-5/40L ™ , PLC-5/60 ™ ,
PLC-5/60L ™ family, PLC-5/80 ™
• PLC-5/250 ™
• PLC scanner modules and subscanners
• SLC 500 ™ with 1747-SN scanner
Product
Number of
Peripherals
Supported I/O Words Module Use
Minimum Maximum ➂
1203-GD1 or
1203-GK1
1336-GM1
1305 AC MICRO Drive ➀ 5 0 8 Yes No
1336 IMPACT™ Drive 6 ➁ 0 8 Yes Yes ➃
1336 PLUS AC Drive 6 ➁ 0 8 Yes Yes ➃
1336 PLUS II Drive 6 ➁ 0 8 Yes Yes
1336 FORCE™ Drive 6 ➁ 0 8 Yes Yes ➃
1336 REGEN Line Regeneration Package 2 0 2 ➄ Yes No
1336 SPIDER Drive 6 ➁ 0 8 Yes Yes
1394 AC Mult-Axis Motion Control System 5 0 8 Yes No
SMC Dialog Plus™ 1 0 2 ➄ Yes No
SMP-3 Smart Motor Protector 2 0 2 ➄ Yes No
1397 Digital DC Drive 5 0 8 Yes No
1557 Medium Voltage Drive 5 0 8 Yes No
2364F Regenerative DC Bus Supply Unit 6 0 8 Yes No
➀ The Remote I/O modules are compatible with 1305 drives using firmware release 2.xx or greater.
➁ Lower horsepower products may not support a sixth peripheral. To connect multiple peripherals to a SCANport product, a port expander may be required. Refer to
the product user manual to verify that it supports a sixth peripheral.
➂ Many SCANport products support 10 words of I/O (Command/Logic, Speed Reference, and four datalinks). Remote I/O, however, supports only 8 words of I/O.
➃ Drive must be B-frame or larger. If it is a 1336 FORCE drive, it must use a standard adapter board.
➄ Datalinks are not supported by this product.