Rockwell Automation 1329I DeviceNet Option FRN 1.XXX - Manual (Page 19)

Chapter
3
Configuring the 1329I Unit and DeviceNet
Option
This chapter provides information and instructions for configuring the
1329I Integrated drive/motor and DeviceNet Option to communicate on a
DeviceNet network. It includes information on the following:
This chapter does not contain information on all possible configurations.
Refer to
Appendix B in this manual for a complete list of parameters. Refer
to the 1329I Integrated Drive/Motor User Manual for information on
configuring the 1329I unit.
Important: In order to configure a 1329I unit and DeviceNet option, they
must be properly installed, commissioned for the DeviceNet
network, and powered (
Chapter 2 ).
Configuration Tools The 1329I Integrated drive/motor and DeviceNet option act as a single
device on the DeviceNet network. You can determine how it behaves by
setting parameters using any of the following configuration tools:
This manual contains instructions for using DeviceNet Manager with a
1329I unit and SLC scanner.
Topic Page
Configuration Tools 3-1
Going Online with DeviceNet Manager 3-2
Creating an EDS File 3-3
Accessing Parameters in the 1329I Unit and Option 3-4
Setting the Node Address
3-5
Setting the Data Rate 3-6
Selecting Input and Output Assemblies 3-7
Enabling Network Control 3-7
Enabling Network Speed Reference 3-8
Setting the Communications Fault Action 3-9
Setting the Idle Action 3-10
Setting the COS (Change of State) Mask 3-10
Resetting the DeviceNet Option 3-11
Method For more information, refer to
DeviceNet Manager software http://www.ab.com and this manual
RSNetWorx for DeviceNet software http://www.software.rockwell.com/navigation/products
TIP: Explicit messaging can also be used to configure the 1329I unit and
DeviceNet option. Refer to
Chapter 6 .