Rockwell Automation 1329I DeviceNet Option FRN 1.XXX - Manual (Page 26)

3-8 Configuring the 1329I Unit and DeviceNet Option
Figure 3.12 Modifying the Network Control Parameter
2. Select Network, and then click Save to Device.
3. Click OK to close the dialog box.
Enabling Network Speed
Reference In order for a scanner to change the speed of the 1329I unit, the unit must be
configured to accept its speed reference from the network.
1. In the Device Configuration - Enhanced Mode dialog box ( Figure 3.8 ),
double-click Parameter 36 - [Speed Ref Source]. The Device
Configuration - Modify Enumerated Parameter dialog box appears.
Figure 3.13 Modifying the Speed Reference Parameter
2. Select Network, and then click Save to Device.
3. Click OK to close the dialog box.