Rockwell Automation 1329I DeviceNet Option FRN 1.XXX - Manual (Page 57)

Parameters B-3
Parameter List
#
Object
Mapping
Name and Description
Access
Rule
(1)
Units/
Range Factory
Default
Drive Display Parameters
01
0x0F-1-1 Command Frequency
Value of the presently selected speed reference. Get 0.1 Hz None
02 0x0F-2-1 Output Frequency
Output frequency to the motor. Get 0.1 Hz None
03 0x0F-3-1 Output Voltage
Output voltage to the motor. Get 1 Volt None
04 0x0F-4-1 Output Current
Output current to the motor. Get 0.1% of
Rated
Current None
05 0x0F-5-1 Load Current
Output current to the motor due to the load. Get 0.1% of
Rated
Current None
06 0x0F-6-1 Bus Voltage
DC Bus voltage level. Get 1 Volt None
07 0x0F-7-1 Power Unit Temperature
Temperature of the 1329I unit. Get 1 °C None
08 0x0F-8-1 Analog Input
The value of the analog speed reference input (terminal 2 or 3 on the control signal terminal
block). Get 0.1% of
Full Scale None
09 0x0F-9-1 TB Input Status
The on (1) and off (0) state of the inputs to the control signal terminal block:
Get Bits None
10 0x0F-10-1 Last Fault
Fault number for the most recent fault.
0 = No Fault
11 = Keypad Fixed Pattern
1 = Function Loss 12 = Keypad Redundant Start
2 = Over Current 13 = TB Redundant Start
3 = Motor Overload 14 = Keypad Connect
4 = Over Voltage 15 = Under Voltage Running
5 = Under Voltage Stop 20 = DNet EEPROM Fault
6 = Over Temperature 21 = DNet Unrecoverable Fault
7 = Communication Loss 22 = No DNet Power
8 = Parameter Checksum 23 = DNet Lost I/O Connection
9 = EEPROM Drive ID 24 = DNet Forced Fault
10 = Keypad Disconnect 25 = DNet Comm Fault
Refer to Chapter 7 for troubleshooting procedures.
Get 0 to 24 None
Drive Program Parameters
30
0x0F-30-1 Minimum Frequency
Lowest frequency that the drive will output continuously. Its value must be less that Parameter
31 - [Maximum Frequency]. Get/
Set
(2)
0 Hz to
60 Hz 0 Hz
31 0x0F-31-1 Maximum Frequency
Highest frequency that the drive will output. Its value must be greater that the value of
Parameter 30 - [Minimum Frequency]. Get/
Set
(2)
50 Hz to
120 Hz 60 Hz
(1) Get = Read. Set = Write. Set access is allowed only if DIP switch 10 on the 1329I Integrated drive/motor is set to On ( Figure 2.3 ).
(2) The parameter can be set only when the drive is stopped.
(3) The parameter can be set only when the 1329 Integrated drive/motor does not have an active I/O connection.
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Bit 8 Bit 9 Bit 10 Bit 11 Bit 12 Bit 13 Bit 14 Bit 15
Stop
Start
Reset
Forward/Reverse
Function Loss
RPM/Percent Load Display
Not Used
Not Used Speed Preset 0
Speed Preset 1
Speed Preset 2
Not Used