Rockwell Automation 1746-BAS-T SLC 500 Basic Basic-T Modules - Manual (Page 51)

Publication 1746-UM004B-EN-P - December 2005
Programming Overview 4-3
Figure 4.2 SLC 5/02 Controller to Module M0 and M1 File Transfer
Module ID Codes
The following table lists the ID codes needed to configure the
memory of your SLC 500 fixed or modular controller.
BASIC Programming
Instructions BASIC programs are composed of BASIC programming instructions
grouped together. These instructions are a combination of BASIC
commands, statements, operators, and system subroutines (CALLs).
Word 0
Word 1
.
.
.
Word 62
Word 63
Word 100
Word 101
.
.
.
Word 162
Word 163
CPU M0 File
BASIC or
BASIC-T
Module Input
Buffer
Word 0
Word 1
.
.
.
Word 62
Word 63
Word 100
Word 101
.
.
.
Word 162
Word 163
CPU M1 File
BASIC or
BASIC-T
Module Output
Buffer
Controller
Module ID Code
1746-BAS 1746-BAS-T
SLC 500, 5/01 3506 3523 (Class 1)
SLC 5/02 and higher 13106 13123 (Class 4)
IMPORTANT
The module operates in two modes: the Command
mode (Direct mode) and the Run mode (Interpreter
mode). You can only enter commands when the
processor is in the Command mode.