Rockwell Automation 1734-AENT, Series B POINT I/O EtherNet/IP Adapter Module User Manual - Manual (Page 37)

Rockwell Automation Publication 1734-UM018B-EN-E - October 2013 27
Configure the Adapter with RSLogix5000 software Chapter 3
Use DHCP Software to
Configure Your Adapter DHCP (Dynamic Host Configuration Protocol) software automatically assigns
IP addresses to client stations logging onto a TCP/IP network.
DHCP is based on BootP and maintains some backward compatibility. The main
difference is that BootP was designed for manual configuration, while DHCP
allows for dynamic allocation of network addresses and configurations to newly
attached devices.
Be cautious about using DHCP software to configure your adapter. A DHCP
server typically assigns a finite lease time to the offered IP address.
When 50% of the leased time has expired, the adapter attempts to renew its IP
address with the DHCP server.
The possibility exists that the adapter will be assigned a different IP address,
which would cause the adapter to cease communicating with the ControlLogix
controller.
See Configure the Adapter with Fixed IP Address in Chapter 4 to configure the
adapter with a fixed IP address.
Chapter Summary This chapter provided instructions on how to configure POINT I/O Adapter
modules through the RSLogix 5000 software and included information on
configuration requirements and setting the network address.
ATTENTION: To avoid unintended control or loss of control, the
I/O adapter must be assigned a fixed IP address. A dynamically provided
IP address should be used only at initial configuration. If a DHCP server is
used, it must be configured to assign the same IP address to your adapter.
Failure to observe this precaution may result in unintended machine motion
or loss of process control.