Rockwell Automation 1734-AENT, Series B POINT I/O EtherNet/IP Adapter Module User Manual - Manual (Page 75)

Rockwell Automation Publication 1734-UM018B-EN-P - October 2013 65
Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software Chapter 5
5. Select Change...
The Module Definition dialog displays.
6. For Connection, select Data.
This configures the controller to make a Direct I/O Connection to the
module.
7. Click OK.
8. From the New Module dialog, click the Connection tab.
The New Module dialog opens.
9. From the New Module dialog, enter 50 for the Requested Packet Interval
(RPI).
10. Keep the following unchecked.
a. Inhibit Module
b. Major Fault on Controller If Connection fails While in Run Mode
11. Click OK.
12. Choose File
→
Save and enter the name and location of the file.