Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 - Manual (Page 110)

6Ć12 AutoMax Programming Executive Version 3.x
Delete locals with unresolved networkĆwide names Ć
deletes Network module variables (the type listed in the
Local column in the Variable Configurator for Network
modules) that have networkĆwide names that cannot be
found in the network database.
Copy database backups from work directory Ć copies
databases that were stored in the AMXWORK directory
during an unsuccessful move back to the currently
selected rack's directory.
Step 3. Enter the slot number to which the variable(s) are attached
as noted in the error message.
Step 4. Select OK to repair the slot or Cancel to return to the Rack
Configurator window without executing the changes.
6.10 GoTo Menu
The GoTo Menu is used to search by name for variables mapped to
modules in the rack. It is also used to zoom in and out of the three
levels (local rack<ĆĆ>remote rack or head<ĆĆ>digital rail) of
configuration forms in the Rack Configurator and to access the
Variable Configurator from the Rack Configurator.
6.10.1 Locating a Variable by Name
Select Search for Variable from the GoTo menu in the Rack
Configurator to locate a variable by name. Follow the procedure
below to search for a variable.
Step 1.
Enter the variable name (no subscripts).
Step 2. Select the option button indicating whether the variable is
a local variable or a networkĆwide variable.
Step 3. Select OK to begin the search. A dialog box will be
displayed indicating if a match was found, the type and
location of the variable found, and the slot number.
Step 4. Select Yes if you want to search for another match. A
dialog box will tell you when there are no additional
matches. Selecting OK will return you to the Search for
Variable dialog box. You can repeat the search or change
the variable name or search mode. Select No to display
the form containing the variable name requested. The
variable name will be selected.
The search procedure will take you into the Variable Configurator.
You can return to the Rack Configurator by zooming out (see
section 7.6 for additional information). However, note that upon
returning to the Rack Configurator, the module that is selected will be
the same one selected before the Search was performed, rather than
the module containing the variable that was searched for.
6.10.2 Zooming In and Zooming Out
The Zoom In command will move you to the next lower level (greater
detail). If there is another hardware level below the selected module
(such as for the Remote I/O module (M/N 57C416), which contains"
the remote I/O network, or the DIgital Rail (M/N 45C1), which contains
2Ćbit I/O modules), zoom in will always take you to that view. At the