Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 - Manual (Page 30)

3Ć2 AutoMax Programming Executive Version 3.x
D Your language (English, Spanish, etc. Some Windows
applications use this setting for languageĆspecific tasks, such as
sorting or case conversion.)
D The kind of local area network you are on, if any
D The printer and printer port you use
D Applications on your hard disk that you want to run with Windows
The following procedure can be used to install the Windows
software.
Step 1.
Insert the diskette labeled Windows Disk 1" in drive A:.
Step 2. Type A:SETUP<CR>
Step 3. Follow the directions on the screen. If you have any
questions about any of the procedures or options, you
can press F1 to access an online help feature.
3.2 Installing and Running the Programming
Executive Software on the Personal
Computer
Before you load the Programming Executive software onto the
personal computer, read carefully both the instruction manual
describing the operation of the personal computer you will be using
and the manual describing the DOS operating system. Note that you
cannot install the Programming Executive software if Windows V3.1,
3.11, or Windows 95 is not already installed on your personal
computer.
You will need to refer to the installation instructions in J2Ć3107, found
in binder J2Ć3108, for the specific steps required to install the
software. Read the instructions carefully and follow all the steps in
the order given to install the software properly.
For Personal Computers with other AutoMax Executives
Installed
Note that you can install the AutoMax Executive V3.x on the same
personal computer with any other version of the Executive software.
The following guidelines apply:
Running Two Versions of V3.5 or Later
Change the EXEC_DRIVE entry in the AUTOMAX.INI file each time
you want to switch between the two versions.
Running Two Versions, V3.0A to V3.4E
Close windows and change the DCSEXDRV environment variable in
the AUTOEXEC.BAT file. Reboot your computer. Then restart
Windows.
Running Two Versions, V3.5 or Later and V3.0A Ć V3.4E
No special commands are required. Simply click the desired icon.
Running Two Versions, V3.X and V2.X
No special commands are required. Simply click the desired icon to
run V3. Type AUTOMAX2 at the DOS prompt to run V2.
Running the Programming Executive
Once you have installed the Executive, you can run it by clicking the
AMX V3 icon in the AutoMax Programmer or typing AUTOMAX3" at
the DOS prompt. Typing AUTOMAX3" will also invoke Windows.