Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 - Manual (Page 163)

12Ć1 On Line Menu: Connect
12.0 ON LINE MENU: CONNECT
The Connect menu is used to change the baud rate, enter the
password, release the password, set or release access, and
enable/disable AUTO RUN for the rack. You can also display a list of
users. These options are described below. To select the Connect
menu, enter C" for at the ON LINE menu shown in figure 11.1. The
resulting menu is shown in figure 12.1.
ON LINE direct AutoMax C: \AMXLIB3/SYSDNR/RACK1
EscăExit
Connect
F1 Help
Direct Set Access AutoRun User list
Network Baud Rate
Config NORMAL Keysw Program Access Task Auto Run DISABLED
Slot Task ăăăă Type ăăPri R C M A Status Slot Task ăăăăăăăăăType Pri R C M A Status
"1 ATASK Bas 7 Stop
6 UDC1TSK Blk A Stop
Release
Figure 12.1 Ć CONNECT Menu
12.1 Changing the Baud Rate
Typing B" for Baud Rate" from the Connect menu shown in figure
12.1 allows you to increment or decrement the default baud rate
used for communication with the rack. For the M/N 57C435
Processor, the default is 19200 baud. For the M/N 57C430A and
57C431, the default is 9600 baud. Use the up and down arrow keys
to increment and decrement the baud rate displayed. The allowable
baud rates are 1200, 2400, 4800, 9600, and 19200 baud.