Rockwell Automation 57C620 AutoMax Programming Executive Version 3.8 - Manual (Page 18)

1Ć4 AutoMax Programming Executive Version 3.x
You must be familiar with all the instruction manuals that describe
your system configuration. This may include, but is not limited to, the
following:
D SĆ3000 SD3000/SF3000 Drive (Binder)
D SĆ3001 SA3000 Drive (Binder)
D SĆ3053 SA3100 Drive (Binder)
D SĆ3002 SA500 Drive (Binder)
D JĆ3616 KERMIT COMMUNICATIONS SOFTWARE
INSTRUCTION MANUAL
D JĆ3618 NORTON EDITOR INSTRUCTION MANUAL
D JĆ3636 COMMON MEMORY MODULE INSTRUCTION
MANUAL
D JĆ3650 AutoMax PROCESSOR MODULE INSTRUCTION
MANUAL
D JĆ3669 AutoMax Pocket Reference
D JĆ3675 AutoMax ENHANCED BASIC LANGUAGE
INSTRUCTION MANUAL
D JĆ3676 AutoMax CONTROL BLOCK LANGUAGE
INSTRUCTION MANUAL
D JĆ3677 AutoMax LADDER LOGIC LANGUAGE INSTRUCTION
MANUAL
D J2Ć3107 ReSource AutoMax and DPS SOFTWARE LOADING
INSTRUCTIONS
D IEEE 518 GUIDE FOR THE INSTALLATION OF ELECTRICAL
EQUIPMENT TO MINIMIZE ELECTRICAL NOISE
INPUTS TO CONTROLLERS
D Microsoft Windows User's Guide
D Your personal computer and DOS operating system manual(s)
D Other instruction manuals applicable to your hardware
configuration
1.3 Related Hardware and Software
This manual includes information about the following hardware and
software:
D ReSource AutoMax Executive Software Version 3.x (M/N 57C395
and 57C397). This software contains both the Executive and the
operating systems to be loaded onto AutoMax Processors and
UDC modules in the rack.
D AutoMax Processor Module (M/N 57C430A and later)
D Microsoft Windows 3.x (M/N 57C389)
D IBMĆcompatible 80386Ćbased personal computers used to run the
AutoMax Executive Software
D Mouse pointing tools