Rockwell Automation 2098 CompactLogix Indexing Motion Accelerator Toolkit Quick Start - Manual (Page 33)

Publication IASIMP-QS011B-EN-P — January 2009 33
Plan System Layout Chapter 3
Modifying Your Motion Panel Layout
Follow the steps in this section if you do not use the basic motion control panel as is and want to
modify your motion panel layout.
1. From the basic motion control panel CAD drawing, remove the equipment you do not need
for your application.
2. Open the CAD drawings of optional equipment you would like to add to your system. From
the Toolkit menu, choose KAT Common Info>Add-In Application Packages.
3. Copy and paste objects from the optional equipment CAD drawings to the basic motion
control panel drawing.
4. Select other hardware as needed.
Refer to Downloading Other Allen-Bradley CAD Drawings on page 34 . Refer to the Literature
Library ( http://literature.rockwellautomation.com ) for access to publications.
5. Determine if your duty cycle and selected components require additional cooling.
Refer to Enclosure Selection in the Ultra3000 Digital Servo Drive Installation Manual,
publication
2098-IN003 , for an enclosure sizing example.