Rockwell Automation 2098 CompactLogix Indexing Motion Accelerator Toolkit Quick Start - Manual (Page 39)

Publication IASIMP-QS011B-EN-P — January 2009 39
Plan System Wiring Chapter 4
Route Cables for Your Motion Panel
The base system enclosure diagrams for the three-axis motion control panel, including noise
zones, is shown below. The enclosure CAD drawings are provided as examples of best-practices
techniques used to minimize electrical noise, as covered in the System Design for Control of
Electrical Noise Reference Manual, publication
GMC-RM001 .
The enclosure diagram provides designators that coordinate with the wiring diagrams, illustrating
where to route your power and I/O cables.
Sample Information from Enclosure Files
IMPORTANT
Refer to the Ultra3000 Digital Servo Drives Installation Manual, publication 2098-IN003 , for
installation and wiring instructions specific to the Ultra3000 drives. For other equipment shown in
your CAD drawings, refer to the installation instructions that came with those products.
LIM Module
Ultra3000 Digital
Servo Drives
(230V AC shown)
CompactLogix
Controller
(L23E shown)
Lin
e Filte
r
(op
ti
ona
l)
Ethernet Modem (optional)
PowerFlex 40
(optional)
CLEAN wireway for noise-sensitive
device circuits.
DIRTY wireway for noise-generating
device circuits.
Noise Zone Legend