Rockwell Automation 2098 CompactLogix Indexing Motion Accelerator Toolkit Quick Start - Manual (Page 65)

Publication IASIMP-QS011B-EN-P — January 2009 65
Chapter
6
Motion FactoryTalk View Integration
In this chapter, you configure your FactoryTalk View ME application file. FactoryTalk View ME
application files (.apa) are included in the Kinetix Accelerator Toolkit.
You can choose:
•
1-, 2-, or 3-axis pre-configured FactoryTalk View ME application file for PanelView Plus 600
terminals.
•
2-axis generic base application file for a variety of PanelView Plus terminals.
After file selection, you configure the communications, add axes if needed, test the project,
download the program, and run the application.
Before You Begin
•
Complete the Kinetix Accelerator Toolkit CD installation. (Refer to Chapter 1 .)
•
Complete your system hardware selection. (Refer to Chapter 2 .)
•
Complete your system layout. (Refer to Chapter 3 .)
•
Complete your system wiring. (Refer to Chapter 4 .)
•
Complete your Logix Integration procedures. (Refer to Chapter 5 .)
What You Need
•
Kinetix Accelerator Toolkit CD, publication IASIMP-SP004
•
FactoryTalk View Studio software, version 5.00 or later
•
RSLinx Enterprise software, version 2.54 or later
•
FactoryTalk View ME application files (CIMME_xaxis_U3k_PVP600_v00x.apa)
FactoryTalk View ME files are available on the Kinetix Accelerator Toolkit CD. For a copy of
the CD, contact your local Rockwell Automation distributor or sales representative.