Rockwell Automation 2098 CompactLogix Indexing Motion Accelerator Toolkit Quick Start - Manual (Page 93)

Publication IASIMP-QS011B-EN-P — January 2009 93
Motion System Application Guide Chapter 7
Use the Fault Log Display
The Fault Log display lets you monitor and/or log motion group, module, axis, or drive fault
events.
Follow these steps to monitor and/or log fault events.
1. Press Fault on the Application Navigation Bar.
The Fault Log display opens.
2. Select a system Fault category
from the Fault window (left).
The green indicator confirms your
fault selection.
3. Monitor the Fault Indicators
(right).
In this example, Axis Fault
indicators are shown. Red
indicators represent a faulted state.
Grey indicators represent a
non-faulted state.
The Logix controller stores the last 50 fault events for each axis. A fault event is triggered by
any non-fault to fault transition for any given axis. The 50 faults are stored on a first-in/
first-out basis.
The indicators displayed correspond to the selected axis.
4. Press the up/down arrows to the left of the selected axis to change the axis.
5. Press the up/down arrows to the right of the selected axis to change the fault event.
Fault events number 0…49. When the fault event number changes, the fault event date/time
and indicators also change.