Rockwell Automation 2098 CompactLogix Indexing Motion Accelerator Toolkit Quick Start - Manual (Page 72)

72 Publication IASIMP-QS011B-EN-P — January 2009
Chapter 6 Motion FactoryTalk View Integration
Adding Axes to the Project
The CIMME_U3k_PVPxxxx_v00x.apa file has two pre-configured axes for use. In this section you
will add additional axes to your Ultra3000 drive system and the project file.
All the displays in the project file are parameterized to facilitate quick editing and reuse
throughout the application. The following Axis Status display contains faults and status
information that is common to all configured axes (Axis1…Axisx).
Axis Status Display
Add the Parameter File
Follow these steps to add a parameter file to your FactoryTalk View ME application.
1. Expand the FactoryTalk View ME Explorer window to gain access to
Parameters.
The parameters list contains the pre-configured axes within the
application. Each parameter file is associated with a specific axis. When
opening the Axis Status display, the tag information loads from the axis
currently selected.
IMPORTANT
If you have selected a pre-configured application with a specific axis count and it fits your
application needs, skip this section and go to
Modifying Axis Names beginning on page 77 .