AJA TruZoom - Manual (Page 29)

TruZoom v1.1 www.aja.com 29
The Status pane reports the progress of the update for three processes— “erasing flash”,
“programming flash”, and “verifying flash.”
Figure 17. Firmware Update Progress Window
.
5. When the firmware update completes, your are prompted to power down both the
Corvid Ultra and the PC system:
• First click Power Off Now to power down the PC
• Then shut down the Corvid Ultra frame
6. Restore system power:
• Power up the Corvid Ultra frame. The Power LED should light blue.
• Then power up the host PC. PC drivers will be loaded during the PC boot up as part
of the Windows load. The Corvid Ultra driver automatically loads FPGAs from disk.
Figure 18. Firmware Update System Power Off Prompt
Caution!
Do not interrupt the firmware update process. Keep the Corvid Ultra frame and PC
powered up and running until the process completes.
If for any reason, the update should fail, then run it again without power-cycling
anything. Ensure that no other application is running on the host computer.