Belkin G+ MIMO F5D9231-4 - Manual (Page 36)

34
G+ MIMO Wireless Router
sections table of contents 1 2 3 4 6 7 8 9 10 5
alTeRnaTe seTUP MeTHOd
Configuring your Wan Media access Controller (MaC) address
All network components including cards, adapters, and routers, have
a unique “serial number” called a MAC address� Your Internet Service
Provider (ISP) may record the MAC address of your computer’s adapter
and only let that particular computer connect to the Internet service�
When you install the Router, its own MAC address will be “seen” by the
ISP and may cause the connection not to work� Belkin has provided
the ability to clone (copy) the MAC address of the computer into the
Router� This MAC address, in turn, will be seen by the ISP’s system as
the original MAC address and will allow the connection to work� If you
are not sure whether your ISP needs to see the original MAC address,
simply clone the MAC address of the computer that was originally
connected to the modem� Cloning the address will not cause any
problems with your network�
Cloning your MaC address
To clone your MAC address, make sure that you are using the computer
that was ORIGINALLY CONNECTED to your modem before the Router
was installed� Click the “Clone” button (1)� Click “Apply Changes” (3)�
Your MAC address is now cloned to the Router�
entering a specific MaC address
In certain circumstances you may need a specific WAN MAC address�
You can manually enter one in the “MAC Address” page� Type in a MAC
address in the spaces provided (2) and click “Apply Changes” (3) to
save the changes� The Router’s WAN MAC address will now be changed
to the MAC address you specified�
(1)
(2)
(3)