Belkin G+ MIMO F5D9231-4 - Manual (Page 52)

50
G+ MIMO Wireless Router
sections table of contents 1 2 3 4 5 7 8 9 10 6
UsInG THe Web-based adVanCed UseR InTeRfaCe
setting MaC address Control
The MAC address filter is a powerful security feature that allows you to specify which computers are allowed on the wireless network� Note: This list
applies only to wireless computers� This list can be configured so any computer attempting to access the wireless network that is not specified in the
filter list will be denied access� When you enable this feature, you must enter the MAC address of each client (computer) to which you want to allow
network access� The “Block” feature lets you turn on and off access to the network easily for any computer without having to add and remove the
computer’s MAC address from the list�
setting up an allow access list
1� Select the “Allow” radio button (1) to begin setting up a list of
computers allowed to connect to the wireless network�
2� Next, in the “MAC Address” field that is blank (3), type in the MAC
address of the wireless computer you want to be able to access
the wireless network, then click “<<Add” (4)�
3� Continue to do this until all of the computers you want to add have
been entered�
4� Click “Apply Changes” (5) to finish�
(1)
(2)
(3)
(5)
(4)