Figure 16, Oil separator (6.2753.200), disassembled – Metrohm 893 Professional Biodiesel Rancimat User Manual
Page 41
■■■■■■■■■■■■■■■■■■■■■■
4 Operation
893 Professional Biodiesel Rancimat
■■■■■■■■
33
Figure 16
Oil separator (6.2753.200), disassembled
1
Body
Body with the IN and OUT connectors.
2
Base
Base with O-ring (6.1454.050) used for seal-
ing the oil separator.
1 Disassembling the oil separator
■
Remove the base.
NOTE
Remove the base carefully.
Do not use sharp or pointed tools.
2 Cleaning the oil separator bodies
■
Clean the oil separator bodies with acetone or 2-propanol or in
the dishwasher and rinse with distilled water.
Pre-clean with dishwashing detergent in the case of severe con-
tamination.
■
Then heat the oil separator bodies in the drying oven for 2
hours at 80 °C.
3 Cleaning the oil separator bases
■
Clean the oil separator bases with 2-propanol or in the dish-
washer and rinse with distilled water.
Pre-clean with dishwashing detergent in the case of severe con-
tamination.
■
Then heat the oil separator bases in the drying oven for 2
hours at 80 °C.
■
Mount new O-rings where necessary.