Metrohm 941 Eluent Production Module - Manual (Page 20)

4.2 Base tray and bottle holder
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
941 Eluent Production Module (2.941.0010)
1 2 3
1 Tilt the instrument sideways and lay it down flat.
2 Loosen the four cylinder screws with the 3 mm hex key and remove
them and their washers.
3 Remove the base tray.
The base tray must always be mounted under the lowermost instrument
of the stack.
Mounting the base tray
Before you can mount the base tray, the following preconditions must be
met:
￭ The instrument is switched off.
￭ The bottle holder is cleared.
￭ All of the cable connections on the rear have been disconnected.
￭ There are no loose parts in the instrument.
￭ The instrument is lying on its side, and the bottom surface is visible.
To mount the base tray, you need a 3 mm hex key (6.2621.100).