Can-Am DS250 - Manual (Page 112)

ELECTRICAL
ƽ
WARNING
Unless otherwise informed, al-
ways turn ignition switch to the
OFF position before performing
any maintenance or repair on elec-
trical system.
Spark Plug
Removal
Unplug spark plug cable.
Unscrew spark plug one turn.
Clean spark plug and cylinder head
with pressurized air if possible.
ƽ
WARNING
Always wear safety goggles when
using pressurized air.
Unscrew spark plug completely then
remove them.
vmo2006-014-066_a
LH SIDE OF ENGINE
1. Spark plug
Installation
Prior to installation make sure that con-
tact surface of cylinder head and spark
plug is free of grime.
Using a feeler gauge, set the spark
plug gap to 0.8 mm (0.31 in).
Apply anti-seize lubricant over spark
plug threads to prevent a possible
seizure.
Screw spark plug into cylinder head by
hand and tighten with a torque wrench
and a proper socket.
Torque spark plugs to 11 N•m
(97 lbf•in).
Battery
ƽ
WARNING
Never charge a battery while in-
stalled in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
CAUTION: Never remove the bat-
tery sealing cap.
Clean battery post with a wire brush.
Apply dielectric grease (P/N 293 550
004) or an equivalent on post to pro-
tect against oxidation.
Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
ƽ
WARNING
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first.
Remove the holding strap.
Remove battery from vehicle.
Cleaning
Clean battery, battery casing, cables
and battery posts using a solution of
baking soda and water.
110
_____________________