Can-Am DS250 - Manual (Page 69)

N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment or towing.
F: Forward
It is the normal driving range. It al-
lows the vehicle to reach its maximum
speed.
6) Multi-Switch Housing
The controls located on this multi-
switch housing are:
vmo2006-013-001_a
TYPICAL — MULTI-SWITCH HOUSING
1. Headlamp switch
2. Engine stop switch
3. Engine start button
4. Override button
5. Choke lever
Headlamp Switch
vmo2006-014-055_a
TYPICAL — HEADLAMP SWITCH
FUNCTIONS
1. Headlamp switch
2. Low beam and taillight
3. High beam and taillight
4. OFF position
Engine Stop Switch
This switch can be used to stop engine
and as an emergency control.
To stop engine, fully release throttle
lever then use the engine stop switch.
NOTE: While engine can be stopped
by turning ignition key to OFF posi-
tion, we recommend the engine be
stopped by the engine stop switch.
vmo2006-014-011_b
ENGINE STOP SWITCH FUNCTIONS
1. Engine stop switch
2. RUN position
3. OFF position
Engine Start Button
To start engine, place the engine stop
switch to RUN position.
Press and hold the engine start but-
ton, release immediately after engine
is started.
vmo2006-014-011_e
TYPICAL
1. Engine start button
2. Engine stop switch
_____________________
67