Can-Am DS250 - Manual (Page 113)

Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery top should be
cleaned by soft brush and any grease-
cutting soap or baking soda solution.
Installation
Reinstall battery in vehicle.
ƽ
WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.
Fuse
If fuses are damaged, replace them by
one of the same rating.
CAUTION: Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuses are located underneath the seat
in the service compartment. Remove
the seat to allow an access at the fuse
holder.
vmr2006-078-001_b
1. Fuse holder
To remove fuse from holder, unclip
and remove holder cover then pull
fuse out. Check if filament is melted.
A15E0KY
1
2
1. Fuse
2. Check if melted
Bulb Replacement
ƽ
WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
Headlamp
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
To unplug connector, release locking
tab then pull on connector using a wig-
gle movement.
_____________________
111