Cooper Instruments & Systems Series M7 Professional Digital Force Gauge - Manual (Page 35)

Series 7 Digital Force Gauges User’s Guide
34
To re-enter the password, press ESC to exit to the home screen. Then, access the desired function and
enter the password again when prompted.
If the password has been misplaced, it can be reset. Press ENTER to generate a request code. The
request code must be supplied to Mark-10 or a distributor, who will then provide a corresponding
authorization code. Enter the activation code to disable the password.
17 OTHER SETTINGS
17.1 Automatic Shutoff
The gauge may be configured to automatically power off following a period of inactivity while on battery
power. Inactivity is defined as the absence of any key presses or load changes of 100 counts or less. To
access these settings, select Automatic Shutoff from the menu. The display appears as follows:
Selection Description
Disabled Disable automatic shutoff.
Enabled Enable automatic shutoff.
Set Minutes The length of time of inactivity. Available settings: 5-30, in 5 minute increments.
Note: If the AC adapter is plugged in, the gauge will ignore these settings and remain powered on until
the POWER key is pressed.
17.2 Backlight
Although the backlight may be turned on and off at any time by pressing the BACKLIGHT key, there are
several available initial settings (applicable upon powering on the gauge). To access these settings,
select Backlight from the menu. The display appears as follows:
AUTOMATIC SHUTOFF
Disabled
* Enabled
Set Minutes
5
BACKLIGHT
Off
On
*
Auto
Set Minutes
1
INCORRECT
PASSWORD
Reset password
Request code:
XXXX