Hudson Robotics SOLO - Manual (Page 35)

35
3.3 – Dispense Step
This step will move the pipettor to a selected dispense position, then dispense the
indicated volume of fluid. The display shown below depicts a Dispense step
expelling 95 uL into well ‘C2’ of a 384-well plate located at Position1 on the
SOLO’s deck on its first execution, then 75 uL into well ‘C6’ on its second
execution:
The parameter selections are identical to those of the Aspirate step, except for the
following:
Mixing – Same as Aspirate step, except in opposite order, but ends with a
dispense as well.
Blow-off – This amount will be expelled from the syringe after the last
‘dispense’ amount in this step is released. It is used to blow off a
droplets that may be on the tip at the end of dispensing.