Canon SX20 - Manual (Page 69)

69
SETTING
UP FUNCTIONS USING
MENUS
You can use the RGB IN-2/COMPONENT
IN/RGB OUT terminal as an analog RGB
terminal.
The RGB IN-2/COMPO-
NENT IN/RGB OUT terminal
is used as an input terminal.
The RGB IN-2/COMPO-
NENT IN/RGB OUT terminal
is used as an output terminal.
When [COMPUTER-2] is selected,
a monitor output setting cannot be
done even if [ANALOG RGB] is
selected for the input signal.
Press the [COMPUTER-1] button
before making a monitor output
setting.
An image can be output to a monitor
through the RGB IN-2/
COMPONENT IN/RGB OUT
terminal only when [Computer-1]
and [ANALOG RGB] are selected
for the input signal.
Outputting an
Image to a Monitor
System Settings
Menu
This menu is used to set various functions
of this projector.
Outputting an Image to a Monitor
[Terminal] ........................................ P69
Selecting the Power Management Mode
[Power management mode] .......... P70
Issuing a Beep
[Beep] .............................................. P70
Prohibiting Projector Operation
[Key lock] ........................................ P71
Registering a Password
[Register password]....................... P71
Setting a Password
[Password settings] ...................... P72
Setting up the Remote Control
[Remote control] ............................ P72
Selecting a Display Language
[Language]...................................... P73
Resetting to Factory Defaults
[Factory defaults] ........................... P73
Resetting the Lamp Counter
[Lamp counter] ............................... P74
System settings
Terminal