Canon SX20 - Manual (Page 78)

78
MAINTENANCE
Procedure for Replacing the Lamp
Turn off the projector and disconnect
the power plug from the AC outlet.
Allow the projector to cool for a least
1 hour.
Detach the lamp cover by loosening
a screw with a flathead screwdriver.
Loosen two screws, turn up the
handle, and remove the lamp.
Insert a new lamp as far as it will go
and secure it with two screws.
* After installation, be sure to turn
down the handle.
Install the lamp cover and tighten the
screw.
Turn on the projector.
Bring up the menu and select
[System settings] -> [Lamp counter].
(P74)
Select [Reset] -> [OK] to reset the
lamp counter.
Lamp
Screws
Handle
1
2
Screw Lamp cover
Lamp cover
8
7
6
5
3
4