Baumer G1-G2-GB-GXxxx - Manual (Page 2)

Manual_ProGeber_V1-40_EN.doc 2/40 Baumer IVO GmbH & Co. KG
10.05.11 Villingen-Schwenningen, Germany
Content
1 Introduction 4
1.1 Product assignment 4
2 General information 5
2.1 System requirements 5
2.2 Installation 5
2.3 Software state 5
2.4 Notes for operation 6
3 The program ProGeber 7
3.1 Basic information 7
3.2 Program run 7
3.2.1 Select encoder 8
3.2.2 Encoder connected to PC "Automatic choose" 9
3.2.3 Select type of encoder from table "Manual choose" 10
3.2.4 Start programming of encoder 11
4 Program encoder 13
4.1 Menu bar 13
4.1.1 File 13
4.1.2 Settings 14
4.1.3 Extras
15
4.1.4 Info 16
4.1.5 Reprogramming 16
4.1.6 Load programming
16
4.1.7 Save programming 16
4.1.8 Print 16
4.1.9 Load encoder data 16
4.1.10 Save data in encoder 16
4.1.11 Display the position 16
4.2 Explanation of programming mask „resolution“ 17
4.2.1 Code (steps) 18
4.2.2 Code (Revolutions) 18
4.2.3 Code format 18
4.2.4 Counting direction 19
4.2.5 Preset (offset) 19
4.2.6 Revolutions 19
4.2.7 Steps / revolution
19
4.2.8 Entire resolution 20
4.2.9 Back to main menu 20
4.2.10 Dialog window 20
4.2.11 Display type of encoder 20
4.2.12 Read encoder data 21
4.2.13 Send encoder data 21
4.3 Explanation of programming mask „outputs“ for parallel encoders 22
4.3.1 Special outputs 23
4.3.2 Least significant bit (LSB) revolutions 23
4.3.3 Domain „special outputs“ 23