Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 31)

Crestron Commercial Lighting Design Guide
27
Power Switching
GLXP-DIMFLV8
The GLXP-DIMFLV8 is a Crestron Green Light switching module
which features 8 channels of 4-wire, 0-10 Volt fluorescent
dimming. The module is part of a complete Crestron
engineered GLPS Green Light switching panel.
> 8 channels of 4-wire 0-10 Volt fluorescent dimming
> Compatible with lighting and motor loads
> Supports 100 to 277 Volt applications
> 16 Amp, 1 HP load rating per channel
> Arcless switching
> Positive air gap at each output
> Phase-independent channels
> Cresnet communications
>
Redundant power capability—module powered via line
or Cresnet
> Local controls for testing and verification
> Local and remote override capability
> Non-volatile power failure memory
Load Ratings
Dimmer Channels 8
Per Channel 16 Amps at 100-277 Volts AC, 50/60 Hz
0.5 HP @ 120 Volts, 1 HP @ 230 Volts, 1 HP @ 277 Volts
Switch Load Types Incandescent, Magnetic Low-Voltage, Electronic Low-Voltage, Neon/Cold Cathode, Fluorescent
Ballast, High-Intensity Discharge, Motor
Relay Lifetime 1,000,000 on/off operations at full electronic ballast load
Power Requirements
Primary 100-277 Volts AC, 50/60Hz, supplied via channel 1 (L1, N1)
Secondary (optional) 5 watts at 24 Volts DC, supplied via Cresnet®
Environmental
Temperature 32° to 104°F (0° to 40°C)
Humidity 10% to 90% RH (non-condensing)
Heat Dissipation 116 BTU/Hr
Electrical Regulatory Certifications
UL508, Section 41 (Endurance Test) and Section 61C (Electronic Ballasts)
UL924, Emergency Power Equipment
IEC60669-2-1, Section 19.102 (Contact mechanisms incorporated in electronic switches, intended for fluorescent lamp circuits or
other capacitive loads)
Module SCCR Rating - 65kA
CE