Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 70)

Crestron Commercial Lighting Design Guide
66
Accessories
DIN-AO8
The DIN-AO8 is a DIN rail automation control module that provides eight analog output
ports for interfacing with third-party lighting and heating/cooling systems.
x Eight 0-10 V analog output control ports (maximum sink current 20mA per
channel)
x Interface for 3rd-party lighting and heating/cooling
x Programmable functionality via DIN-AP2
x Setup via front panel or software
Analog Outputs
Each analog output port provides a 0 to 10 Volt DC control signal ideally suited for
controlling 0-10 V lighting dimmers and heating/cooling valves. 10-bit resolution ensures
precise recall of lighting and climate control settings and smooth ramping between levels.
DIN-IO8
The DIN-IO8 is a DIN rail automation control module that provides eight Versiport I/O ports
for interfacing with a wide range of third-party devices and systems. Each Versiport can be
configured via software to function as a digital or analog sensing input or as a digital
trigger output.
x 8 Versiport I/O ports
x Interface for 3rd-party sensors, detectors, contact closures, and alarms
x Fully programmable functionality via DIN-AP2
Versiport
Configured as a digital input, the Versiport senses a contact closure or logic level signal
from devices such as motion detectors, partition sensors, alarm panels, 12 V triggers, and
all types of switches and relays. As an analog input, the Versiport can sense changes in a
resistance or DC voltage level, working with everything from temperature and light sensors
to water level meters to volume control potentiometers. As a digital output, the Versiport
provides a logic level closure signal to trigger control and alarm inputs on a variety of
external devices.
DIN-HUB
The DIN-HUB is a DIN rail Cresnet hub designed to facilitate the configuration of large
Cresnet networks.
x 3-segment Cresnet hub
x 20 additional Cresnet devices per segment
3-Segment Cresnet Hub
Cresnet is the communications backbone for Crestron lighting modules, wall box dimmers,
shade controllers, thermostats, keypads, touchpanels, and many other devices. Cresnet
normally supports up to 20 Cresnet devices without requiring a hub. Adding a DIN-HUB
allows more devices. The DIN-HUB features three isolated Cresnet segments, each
supporting an additional 20 devices, allowing for systems of approximately 80 devices
total (including the "host" segment). More hubs may be added to allow up to a maximum
potential of 252 devices.