Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 49)

Crestron Commercial Lighting Design Guide
45
Room Solutions
Cameo Dimmers and Switches
Cameo ® dimmers and switches are designed to replace any
standard in-wall dimmer or switch. Although the following
devices are functional as a standalone dimmer or switch, they
deliver greatly enhanced functionality as part of a complete
Crestron control solution. When connected to a Crestron PAC2 or
PAC2M automation control system (or any other 2-Series control
system), extensive automation and control capability is enabled.
In addition to replacing standard dimmers and switches, Cameo
remote “slave” units replace traditional 3- or 4-way lighting
dimmers and switches. The slave units connect to the main
dimmer or switch through the 120 Volt traveler wire. Up to 10
slave units can be connected to a single Cameo dimmer or
switch.
Cameo Dimmer
with 2-way rocker
(depicted with face plate)
Cameo Switch
with 2-way rocker
(depicted with face plate)
Dimmer Derating
Dimmers generate heat during operation. When dimmers are placed in close proximity, such as in a wall-box, their ability to
dissipate heat is reduced. To increase lifetime and avoid overheating, the max load ratings are reduced accordingly. For each
dimmer there are three ratings: single, one side shared, and two sides shared. See the derating graphics below for examples.
Example Cameo Dimmers and Switches Application
Maximum Loads for Cameo Dimmer/Switch Combos Maximum Loads for Cameo Dimmers
500 VA
SW
1 A
DIM
400 VA
SW
1 A
DIM
400 VA
SW
1 A
DIM
400 VA
SW
1 A
DIM
250 VA
SW
1 A
DIM
400 VA
SW
1 A
DIM
600VA 600VA 600VA 600VA 400VA
750VA
PWR
NET
ACTIVITY ACQUIRE
SETUP
CEN-RFGW
-EX
LAN PoE
2W NET
G Z
Y 24
CRESTR
ON
CEN-RFGW
-EX
CONTROL
SYSTEM
CL
W-DIMSWEX-P
EXHAUST
FAN
LIGHTS
FA
N
120 VAC
CL
W-DIMEX-P CL
W-SL
V-
P
CL
W-SL
V-
P
LIGHTING LIGHTING
Color Key
AC
Cresnet