Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 71)

Crestron Commercial Lighting Design Guide
67
Accessories
DIN-BLOCK
The DIN-BLOCK is a DIN rail Cresnet distribution block designed to facilitate the
termination of Cresnet wiring at a head end or distribution point.
x 12 port Cresnet distribution block
x Detachable screw terminal blocks for easy termination and troubleshooting
x Split power bus for flexible 24V power distribution
x Diagnostic LEDs for network power and data
x Passive device — no programming required
Cresnet Distribution
Cresnet is the communications backbone for Crestron lighting modules, wall box dimmers,
shade controllers, thermostats, keypads, touchpanels, and many other devices. Cresnet
allows for combinations of homerun and daisy chain wiring, and the DIN-BLOCK provides
a simple means for connecting up to 12 separate Cresnet cables as part of any sized
network.
DIN-PWS50
The DIN-PWS50 is a 50 Watt Cresnet power supply module designed to snap onto a
standard DIN Rail installation. All wiring connections are made using screw terminals
positioned along the top and bottom, clearly accessible from the front for easy installation
and servicing. Three Cresnet power ports are provided.
x 50 Watt Cresnet power supply module
x Powers the DIN-AP2 Automation Processor and other Cresnet devices
x Includes 3 Cresnet power ports
x Cresnet data passes through unaffected
x Dual line power input terminals for easy daisy chaining
CLX-PWS75
The CLX-PWS75 is a 75 Watt Cresnet power supply designed to mount in a CAEN
enclosure. A single CLX-PWS75 can be installed in any single-width enclosure, or up to two
may be installed side-by-side in a double-width enclosure. Four Cresnet power ports are
provided on the CLX-PWS75, which may be used to supply power directly to Cresnet
devices, or connect to the external power input ports of a PAC2 or PAC2M.
x 75 Watt Cresnet power supply module
x Occupies a single module space in a CAEN automation enclosure
x Provides supplemental power for systems with multiple keypads, touchpanels,
and other Cresnet devices
x Ideal for use with the PAC2 and PAC2M
GLA-PWS50
The GLA-PWS50 is a 50 Watt Cresnet power supply designed for wall mounting. The GLA-
PWS50 mounts conveniently over a 4" square or 2-gang electrical box. All connections are
made inside the electrical box via flying leads using twist-on wire connectors. A partition is
included to isolate high voltage from Class 2 wiring within the box.
x 50 Watt Cresnet power supply
x Powers the IPAC and other Cresnet devices
x Provides backup power for Crestron Green Light cabinets
x Mounts to a 4" square or 2-gang electrical box