Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 38)

Crestron Commercial Lighting Design Guide
34
Green Light Express
GLXX-2DIM8
The GLXX-2DIM8 is a Crestron Green Light Express dimming module
which features 8 channels of incandescent, magnetic low-voltage, and 2-
and 3-wire fluorescent dimming. The module is part of a complete
Crestron engineered GLPX Green Light Express dimming or switching
panel.
> 8 channels of incandescent, MLV, 2-wire fluorescent dimming
> 4 channels of 3-wire fluorescent dimming
> Phase-synchronous detection eliminates lamp flicker
> Selectable non-dim mode
> Supports 100 to 277 Volt applications
> 16 Amp load rating per
çchannelS
> Short circuit and overload protection
> Positive air gap at each output
> Phase-independent channels
> Cresnet communications
> Redundant power capability—module powered via line or Cresnet
> Local controls for testing and verification
> Local and remote override capability
> Non-volatile power failure memory
Load Ratings
Switch Channels 8
Per Channel 16 Amps at 100-277 Volts AC, 50/60 Hz çSPLITçAMONGççCHANNELS
Dim Load Types
Incandescent, Magnetic Low-Voltage, Neon/Cold Cathode, 2- wire Fluorescent Ballast, or 3-wire
Fluorescent Ballast (uses adjacent channel for 3rd wire, i.e. channels 1 & 2 are to be used for one 3-
wire load)
Switch Load Types Incandescent, Magnetic Low-Voltage, Electronic Low-Voltage, Neon/Cold Cathode, Fluorescent
Ballast, High-Intensity Discharge
Power Requirements
Primary 100-277 Volts AC, 50/60Hz, supplied via channel 1 (L1, N1)
Secondary (optional) 5 watts at 24 Volts DC, supplied via Cresnet®
Environmental
Temperature 32° to 104°F (0° to 40°C)
Humidity 10% to 90% RH (non-condensing)
Heat Dissipation 154 BTU/Hr
Electrical Regulatory Certifications
UL508, Section 41 (Endurance Test) and Section 61C (Electronic Ballasts)
UL924, Emergency Power Equipment
IEC60669-2-1, Section 19.102 (Contact mechanisms incorporated in electronic switches, intended for fluorescent lamp circuits or
other capacitive loads)
SCCR Rating - 65kA
CE